Remove the engine/hydrostatic pump assembly from the loader. (See Hydraulic Pump Removal And Installation on Page 30-40-8.) Loosen the drive belt tensioner (Item 1) [Figure…

There are four replenishing/high pressure relief valves (Item 1) [Figure 30-40-1] in the hydrostatic pump assembly. Two are located at the top of the pumps…

If the charge pressure is not correct loosen the charge relief valve plug (Item 1) [Figure 30-30-2]. Assemble: Always use a new O-ring. Tighten the…

Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Open the rear door. Disconnect the wires (Item 1) [Figure 30-30-1]…

Open the rear door. Disconnect the wires (Item 1) [Figure 30-30-1] from the charge pressure sender. Remove the charge pressure sender (Item 2) [Figure 30-30-1]…

Put the motor carrier housing in the press as shown [Figure 30-20-65]. Use 4-5/16 inch driver tool and press the new inner bearing race into…

It is necessary to locate or fabricate a press tool for this procedure. Refer to photo [Figure 30-20-59] for the correct dimensions of the tool…

Raise the loader lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Lift and block…