Remove the tubeline (Item 1) [Figure 20-41-102]. Remove the check valve fitting (Item 1) [Figure 20-41-103] from the hydraulic control valve. Installation: Lubricate the O-ring…

Remove the main relief valve (Item 1) [Figure 20-41-100]. Remove the O-rings from the main relief valve (Item 1) [Figure 20-41-101]. Installation: Always use new…

Remove the fitting (Item 1) [Figure 20-41-98] from the valve. Check the lift arm bypass orifice (Item 1) [Figure 20-41-99]. NOTE: This orifice is not…

Locate the two BICS lock valves, (Item 1) is for the tilt circuit, and (Item 2) [Figure 20-41-93] is for the lift circuit. Remove the…

Remove the nut (Item 1) [Figure 20-41-89] from the solenoid stem. Installation: Tighten the nut to 53 in.-lb. (6 N•m) torque. Remove the solenoid coil…

Remove the nut (Item 1) [Figure 20-41-85] from both solenoids. Installation: Tighten the nut to 48 – 72 in.-lb. (5 – 8 N•m) torque. Remove…

Disconnect the tubelines (Item 1) [Figure 20-41-79] from the spool centering block. Remove the three screws (Item 2) [Figure 20-41-79] from the spool centering block.…

Remove the end cap block. Remove the spacer (Item 1) and O-ring (Item 2) [Figure 20-41-71] from the tilt spool. Disconnect the tubeline (Item 1)…

The tool listed will be needed to do the following procedure: MEL 1285 – Spring Tool Remove the end cap block from the control valve.…

Remove the lift and tilt actuators from the control valve. Disconnect the tube line (Item 1) [Figure 20-41-50] from the end cap block. Remove the…