Disconnect the hoses (Items 1 & 2) [Figure 20-22-3] from the cylinder fittings. Install plugs and cap in fittings. Remove the bolts (Item 1) [Figure…

Tilt the Bob-Tach forward, so it is parallel to the floor [Figure 20-22-1]. Disconnect the hose (Item 1) [Figure 20-22-1] from the power Bob-Tach cylinder…

Use the following tools to service the cylinder: MEL1074 – O-ring Seal Hook MEL1396 – Seal Installation Tool MEL1033 – Rod Seal Installation Tool Piston…

Remove the retainer nut (Item 1) [Figure 20-21-7] and bolt from the base end pivot pin. Installation: Tighten the retainer nut and bolt to 25…

Remove the old seal (both sides) from the end of the tilt cylinder [Figure 20-21-6]. Apply a light coat of grease on the new seals…

Remove the attachment. Roll the Bob-Tach forward and lower the lift arms. Place the Bob-Tach flat on a pallet to allow the tilt cylinder base…

Remove the attachment. Roll the Bob-Tach fully back. Stop the engine. Raise the seat bar. Disconnect the hose (Item 1) [Figure 20-21-1] which goes to…

Use the following tools to service the cylinder: MEL1074 – O-ring Seal Hook Spanner Wrench MEL1033 – Rod Seal Installation Tool MEL1396 – Seal Installation…