Remove the fitting (Item 1) [Figure 20-40-19] from the check valve. Remove the lift load check valve (Item 2) [Figure 20-40-19]. Installation: Lubricate the O-ring…

Lift and block the loader. (See Procedure on Page 10-10-1.) Raise the lift arms and install an approved lift arm support device. (See Installing on…

The hydraulic control valve is located inside the main frame on the right hand side, below the operators cab. The hydraulic control valve [Figure 20-40-1]…

Remove the four motor cover mounting screws (Item 1) [Figure 20-30-6]. Installation: Tighten the mounting screws to 15 – 20 ft.-lb. (20 – 27 N•m)…

If the pressure is not correct, adjust the main relief valve. Remove the end cap (Item 1) [Figure 20-30-5]. Turn the adjusting screw in or…

The tools listed will be needed to do the following procedure: MEL10003 – Hydraulic Tester MEL10006 – Hydraulic Test Kit Turn the key switch to…

The main relief valve limits the hydraulic system pressure by opening at a certain pressure and allowing the hydraulic oil to flow back to the…

Use the following tools to service the cylinder: MEL1074 – O-ring Seal Hook Spanner Wrench MEL1396 – Seal Installation Tool MEL1033 – Rod Seal Installation…