Steering Drift Compensation can be used to reduce steering drift to maintain a desired travel path. Examples of applications where this feature can be used:…

Place the loader on jackstands. (See Procedure on Page 10-10-1.) Operator must be in the seat and the seat bar down. Close the cab door.…

The controller uses a calibration sequence to optimize the control system. The optimizing ensures full spool stroke (full flow) while preventing over stroke (loading) of…

The controller uses a calibration sequence to optimize the control system. The optimizing ensures full spool stroke (full flow) while preventing over stroke (loading) of…

[Figure 60-160-1] Excessive actuator loading can occur if the actuator and valve spool components are misaligned. Misalignment may reduce spool stroke performance and reduce the…

Calibration procedures must be followed when replacing a hydraulic control valve, actuator, Drive / Drive+ Controller, ACS Controller, pump controller, hydrostatic pump, or hydrostatic motor.…

The tools listed will be needed to do the following procedure: Order from Bobcat Parts P/N: 6689779 – Remote Start Tool (Service Tool) Kit Kit…

The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL1565 – Service Tool Harness Control MEL1566…

NOTE: All diagnostics must be done at the fourteen pin connector (Item 1). (If so equipped as a dealer installed kit.) The ACD (Attachment Control…

NOTE: All diagnostics must be done at the fourteen pin connector (Item 1). The ACD (Attachment Control Device) Icon, located in the right instrument panel…