Touch one probe to one of the slip rings and the other probe to the rotor shaft [Figure 60-30-11]. There should be no continuity. Replace…

Touch the probes to the slip rings [Figure 60-30-10]. The ohmmeter should read between 3.065-33.85 ohms. If there is no continuity replace the rotor.  

Touch one probe to a bare stator lead and the other probe to the bare metal surface of the stator [Figure 60-30-9]. There should be…

Use an ohmmeter to test the stator. Touch the probes to two of the bare stator wires [Figure 60-30-8]. Move one of the probes to…

Disassemble the alternator. [Figure 60-30-7]. Remove the regulator cover and regulator. Remove the four bolts holding halves together. Pry the halves apart (use a press…

Place jack stands under the rear corners of the loader. Raise the lift arms and install an approved lift arm support device. (See Installing Lift…

Connect the positive (+) voltmeter lead to the positive (+) battery terminal [Figure 60-30-4]. Connect the negative (-) voltmeter lead to the negative (-) battery…

The alternator is removed from the loader for clarity purposes [Figure 60-30-3]. Disconnect the negative (-) cable from the battery. Install the wires in their…

Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Disconnect the negative (-) cable from the battery. NOTE: The photo’s…

Stop the engine. Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Loosen the alternator mounting bolt (Item 1) [Figure 60-30-1]. Loosen…