The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10003 – Hydraulic Tester MEL10006 – Hydraulic…
The hydraulic gear pump is attached to the end of the hydrostatic pumps and is located on the left side of the loader. The hydraulic…
The hydraulic gear pump is attached to the end of the hydrostatic pumps and is located on the left side of the loader. The hydraulic…
Install the valve body in a vise and remove the valve (Item 1) [Figure 20-50-4] The valve body can be removed from the mounting bracket…
Install jackstands under the rear corners of the loader. Raise the operator cab. (See Raising on Page 10-30-1.) Remove the Remove the knob and washer…
Raise the lift arms 6 feet (2 m) off the ground. Stop the engine. Turn the Lift Arm Bypass Control Knob (Item 1) [Figure 20-50-1]…
The lift arm bypass control valve is located in front of the operatorโs seat. The lift arm bypass control valve is manually operated by turning…
Assembly: The plastic bushing (Item 1) [Figure 20-40-86] is inserted from the bottom of the flange as shown. Remove the two nuts (Item 1) [Figure…
Remove the hair pin (Item 1) [Figure 20-40-84] and the link from the auxiliary spool on the control valve. Remove the bolt (Item 1) [Figure…
To install new spool seals when the centering spring (tilt spool) or other detent assembly (lift spool) are not removed from the spool, use the…