The oil cooler cools the loaders hydraulic and hydrostatic oil. Oil passages are coiled into a heat exchanger. The cooling fan forces air around the…
Lift and block the loader. (See Procedure on Page 10-10-1.) Remove the fluid from the hydraulic reservoir. (See Removing And Replacing Hydraulic / Hydrostatic Fluid…
The hydraulic fluid reservoir is a storage container for the loaders hydraulic/hydrostatic fluid. The reservoir contains a vented fill cap with a fluid screen to…
Remove the filter (Item 1) [Figure 20-70-4]. Remove the temperature sender (Item 1) [Figure 20-70-5] from the filter block. Assembly: Apply thread sealer to the…
Put jackstands under the front and rear of the loader. (See Procedure on Page 10-10-1.) Raise the lift arms and install the lift arm support…
The hydraulic/hydrostatic filter helps to remove contaminants from the hydraulic fluid when the hydraulic/ hydrostatic systems are operating. The hydraulic/hydrostatic filter housing contains the charge…
NOTE: Always use new O-rings, gaskets, and seals when assembling the hydraulic pump. Put the hydraulic pump in the vise. Put a mark across the…
Ensure the hydraulic reservoir is filled to the correct level before starting the engine. (See Checking And Adding Fluid on Page 10-120-1.)
Raise the lift arms and install the lift arm support device. (See Installing on Page 10-20-1.) Stop the engine and raise the seat bar. Lift…