Stop the engine and open the rear door. Loosen the radiator cap (Item 1) [Figure 70-50-1] from the radiator fill neck. Remove the rear grill.…

Disconnect the wire harness connector (Item 1) [Figure 70-40-1] from the air cleaner sensor on the air cleaner. Loosen the hose clamp (Item 1) [Figure…

Open the rear door and raise the rear grill. Remove the exhaust pipe clamp (Item 1) from the muffler (Item 2) [Figure 70-30-1]. Disconnect the…

Loosen the two control lever mounting bolts (Item 2) [Figure 70-20-1] and remove the mounting nuts (Item 2) [Figure 70-20-3]. Assembly: Do not lubricate the…

Raise the lift arms and install an approved lift arm device. (See Installing Lift Arm Support Device on Page 10-20-1.) Raise the operator cab. (See…

NOTE: The key Switch fully left position activates solenoids number 1 and 4. The high flow rocker switch in the left side instrument panel must…

The wire connector (Item 2) [Figure 60-123-54] can be removed from the solenoid wires, use the following procedure. Remove the wedge (Item 1) [Figure 60-123-55]…

Remove the two bolts (Item 1) [Figure 60-123-52] from the foot sensor shield. Installation: Tighten the bolts to 80-90 in.-lbs. (9,0-10,2 Nm) torque. Disconnect the…

The wire connector (Item 1) [Figure 60-123-49] can be removed from the sensor wires, use the following procedure. Remove the wedge (Item 1) [Figure 60-123-50]…

Remove the two bolts (Item 1) [Figure 60-123-47] from the end of the foot sensor. Installation: Tighten the bolts to 90 in.-lbs. (10,2 Nm) torque.…