Disconnect the glow plug cables and leads. Use an ohmmeter to check the glow plugs [Figure 70-70-4]. Touch one probe to the end of the…

The tools listed will be needed to do the following procedure: MEL10630 – Engine Compression Kit MEL1352 – Compression Adapter The engine must be at…

NOTE: For procedures requiring the use of LOCTITE #242 adhesive, thoroughly clean and dry affected parts before the application of LOCTITE #242. The backlash tolerance…

NOTE: (See Gearbox Disassembly on Page 70-60-7.) when ordering parts for the Fan Gearbox. NOTE: Do not install the seals and cap in the housing…

NOTE: When repairing the gearbox order the following as needed. 1. Complete Assembly 2. Long Housing Assembly 3. Long Housing 4. Short Housing Assembly (See…

Remove the lock nut (Item 1) and spacer (Item 2) [Figure 70-60-14]. Installation: Tighten the nut to 45-55 ft.-lbs. (61-75 Nm) torque. Use the following…

To replace the blower housing grill, remove the four mounting bolts (Item 1) [Figure 70-60-13] from the grill. Install the new grill and replace the…

Put jackstands under the rear corners of the loader. Raise the lift arms and install an approved lift arm device. (See Installing Lift Arm Support…

Loosen the idler pulley bolt (Item 1) [Figure 70-60-1]. Installation: Install the retainer bracket (Item 2) [Figure 70-60-1] for the fan belt at the 3…