With the seat bar down and the ignition key off (keyless panel power off), fully stroke both control handles in toward the center of the…

Switch the rocker switch (Item 1) [Figure 60-123-38] to the hand control mode. With the seat bar down, turn the ignition key on (keyless panel…

The new controller uses a calibration sequence to optimize the control system. The optimizing ensures full spool stroke (full flow) while preventing over stroke (Loading)…

The wire connector (Item 1) [Figure 60-123-35] can be removed from the solenoid, use the following procedure. Remove the wedge (Item 1) [Figure 60-123-36] from…

Remove solenoid (Item 1) from the solenoid mount (Item 2) [Figure 60-123-33]. Installation: Apply a drop of oil to the solenoid threads and tighten solenoid…

Disconnect the harness connector (Item 1) [Figure 60-123-31] from the handle sensor connector. Disconnect the harness connector (Item 2) [Figure 60-123-31] from the handle lock…

Disconnect the harness connector (Item 1) [Figure 60-123-31] from the handle sensor connector. Disconnect the harness connector (Item 2) [Figure 60-123-31] from the handle lock…

Remove the actuator from the hydraulic control valve. (See Actuator Removal And Installation on Page 20-41-8.) Check the mounting block (Item 1) [Figure 60-123-29] and…

When installing the new switch handle, tape the wire terminals together. The switch handle comes with a 6 inch piece of heat shrink tube side…

NOTE: Switch handle can be removed and installed while in loader. Disconnect the harness connector (Item 1) [Figure 60-123-11] from the handle sensor connector. Disconnect…