The Advanced Control System (ACS) has a built-in diagnostic function which uses an icon on the right instrument panel to indicate the condition of the…

Control Handle (Item1) [Figure 60-122-1]. Handle Sensor (Item 2) [Figure 60-122-1]. NOTE: The calibration procedure must be followed when replacing handle sensor, foot pedal sensor,…

Remove the actuator from the hydraulic control valve. (See Actuator Removal And Installation on Page 20-41-8.) Check the mounting block (Item 1) [Figure 60-121-26] and…

To remove the switch handle, the connector (Item 1) [Figure 60-121-18] must be removed from the wires. Remove the wedge (Item 1) [Figure 60-121-19] from…

The wire connector (Item 1) [Figure 60-121-15] can be removed from the handle sensor wires, use the following procedure. Remove the wedge (Item 1) [Figure…

Lift the boot cover (Item 1) [Figure 60-121-7]. Disconnect the harness connector (Item 1) [Figure 60-121-8] from the handle sensor connector. Remove the handle sensor…

Remove the control panel from the loader. (See Removal and Installation on Page 50-100-1.) Disconnect the wiring harness connectors from the controller (Item 1) [Figure…

The Advance Hand Control System (AHC) has a built-in diagnostic function which uses an icon on the right instrument panel to indicate the condition of…