Control Handle (Item 1) [Figure 60-121-1]. Handle Sensor (Item 2) [Figure 60-121-1]. Control Valve Actuators (Item 1) [Figure 60-121-2]. AHC/PWM Controller (Item 1) [Figure 60-121-3].…

Remove the actuator from the hydraulic control valve. (See Actuator Removal And Installation on Page 20-41-8.) Check the mounting block (Item 1) [Figure 60-120-18] and…

Remove the handle control unit from the steering lever. (See Control Handle Removal And Installation on Page 50-111-5.) To remove the switch handle the connector…

The wire connector (Item 1) [Figure 60-120-7] can be removed from the handle control unit wires, use the following procedure. Remove the wedge (Item 1)…

Remove the control panel from the loader. (See Removal and Installation on Page 50-100-1.) Disconnect the wiring harness connectors from the controller (Item 1) [Figure…

The Advance Hand Control System (AHC) has a built-in diagnostic function which uses an icon on the right instrument panel to indicate the condition of…

Control Handle (Item1) [Figure 60-120-1]. Handle Control Unit (Item 2) [Figure 60-120-1]. Control Valve Actuators (Item 1) [Figure 60-120-2]. AHC/PWM Controller (Item 1) [Figure 60-120-3].…

Apply a bead of polyurethane sealer (P/N 6633583) (Item 1) [Figure 60-110-12] around the bolt holes on the blocks. Install the electric solenoid/bracket assembly (Item…

The part number listed will be needed to do the following procedure: P/N 6633583 – Polyurethane Raise the loader lift arms and install an approved…