Remove the nut (Item 1) [Figure 20-41-80] from both solenoids. Installation: Tighten the nut to 8-12 ft.-lbs. (11-16 Nm) torque. Remove the end plate (Item…
Author: Jack
Remove the screws (Item 1) [Figure 20-41-77] from the end cap (both sides). Installation: Tighten the bolt to 90-100 in.-lbs. (10,2-11,3 Nm) torque. Remove the…
Put the linkage end of the spool in the vice [Figure 20-41-73]. Install the spool tool (Item 1) [Figure 20-41-73] over the centering spring. Remove…
Remove the actuators (Item 1) [Figure 20-41-70] from the control valve. (See Actuator Removal And Installation on Page 20-41-8.) Remove the screws (Item 1) [Figure…
Remove the actuator (Item 1) [Figure 20-41-67] from the control valve. (See Lift Spool Removal And Installation on Page 20-41-22.) Remove the screws (Item 1)…
Remove the anti-cavitation valve (Item 1) [Figure 20-41-64] and (Item 1) [Figure 20-41-65] from the control valve.
Loosen the anti-cavitation valve (Item 1) [Figure 20-41-61]. Installation: Always use new O-rings and back-up washers. Tighten to 35-40 ft.-lbs. (47-54 Nm) torque. Remove the…
Loosen the port relief valve (Item 1) [Figure 20-41-57] & [Figure 20-41-58] (Port E1 or F2). (See Port Relief Valve on Page 20-40-19.) Installation: Always…
Loosen the main relief valve (Item 1) [Figure 20-41-54]. Remove the main relief valve (Item 1) [Figure 20-41-55]. Remove the O-rings, sleeve, and glide ring…
Remove the BICS valve assembly from the control valve. (See BICSTM Valve, Removal And Installation on Page 20-41-9.) Remove the four large O-rings (Item 1)…