Wash all parts in clean solvent and use air pressure to dry them. Check the body [Figure 20-60-17]. Check the gear(s) for wear [Figure 20-60-18].…
Author: Jack
Mark the pump sections for correct assembly [Figure 20-60-9]. Remove the pump housing bolts (Item 1) [Figure 20-60-9]. Installation: Tighten bolts to 35 ft.-lbs. (47,5…
Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Stop the engine. Move…
The tools listed will be needed to do the following procedure: MEL1563 – Remote Start Tool MEL10003 – Hydraulic Tester MEL10006 – Hydraulic Test Kit…
Remove the by-pass valve (Item 1) [Figure 20-50-3] from the valve block. Inspect the by-pass valve for damage and replace if necessary. Installation: Tighten the…
Install jackstands under the rear corners of the loader. Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm…
Raise the lift arms 6 feet (2 m) off the ground. Stop the engine. Turn the Lift Arm By-Pass Control Knob clockwise 1/4 turn. Then…
Clean all components with clean solvent and dry with compressed air. Check the spools for wear or scratches. Check that the spools are not loose…
Remove the plug (Item 1) [Figure 20-41-84] or optional port relief valve from the control valve. NOTE: Optional port relief (Item 1) [Figure 20-41-84] is…