Stop the engine and open the rear door. Remove the negative (-) and positive (+) cables from the battery. Disconnect the ground wire (Item 1)…
Author: Jack
The key switch must be in the OFF position. The battery must be at full charge. The cable connections on the battery must be clean…
Place jackstands under the rear corners of the loader. Raise the lift arms and install an approved lift arm support device. (See Installing on Page…
Turn engine OFF and remove the L & S Terminal connector (Item 1) [Figure 60-30-4] off the alternator. Check the continuity between the โSโ terminal…
Turn engine OFF and remove the L & S terminal connector (Item 1) [Figure 60-30-4] off the alternator. Turn the remote start tool key to…
Open the rear door. Connect the remote start tool to the loader. (See REMOTE START TOOL KIT-MEL1563 on Page 10-60-1.) Turn the engine on with…
If the charging system malfunctions check the following: Check the condition and tension of the alternator belt. (See Belt Adjustment on Page 60-30-1.) If belt…
Loosen the alternator mounting and adjustment bolts (Items 1 & 2) [Figure 60-30-1] and loosen the belt all the way. Remove the belt and install…
Stop the engine. Raise the operator cab. (See Raising on Page 10-30-2.) Loosen the alternator mounting bolt (Item 1) [Figure 60-30-1]. Loosen the adjustment bolt…