The hydraulic control valve is located inside the main frame on the right hand side, below the operators cab. The hydraulic control valve [Figure 20-40-1]…
Author: Jack
Remove the four motor cover mounting screws (Item 1) [Figure 20-30-6]. Installation: Tighten the mounting screws to 15 – 20 ft.-lb. (20 – 27 Nโขm)…
If the pressure is not correct, adjust the main relief valve. Remove the end cap (Item 1) [Figure 20-30-5]. Turn the adjusting screw in or…
The tools listed will be needed to do the following procedure: MEL10003 – Hydraulic Tester MEL10006 – Hydraulic Test Kit Turn the key switch to…
The main relief valve limits the hydraulic system pressure by opening at a certain pressure and allowing the hydraulic oil to flow back to the…
Use the following tools to service the cylinder: MEL1074 – O-ring Seal Hook Spanner Wrench MEL1396 – Seal Installation Tool MEL1033 – Rod Seal Installation…
Disconnect the hoses (Items 1 & 2) [Figure 20-22-3] from the cylinder fittings. Install plugs and cap in fittings. Remove the bolts (Item 1) [Figure…
Tilt the Bob-Tach forward, so it is parallel to the floor [Figure 20-22-1]. Disconnect the hose (Item 1) [Figure 20-22-1] from the power Bob-Tach cylinder…
Use the following tools to service the cylinder: MEL1074 – O-ring Seal Hook MEL1396 – Seal Installation Tool MEL1033 – Rod Seal Installation Tool Piston…