At the top side of the control valve, remove the plug (Item 1) [Figure 20-40-37]. Installation: Always use new O-rings (Item 1) [Figure 20-40-38]. Tighten…
Author: Jack
Remove the port relief plug (Item 1) [Figure 20-40-33] from the auxiliary circuit of the control valve. Installation: Always use new O-rings (Item 1) [Figure…
Remove the tilt port relief/anti cavitation valve (Item 1) [Figure 20-40-31] from the rod end of the tilt section. Replace the O-ring (Item 1) [Figure…
Remove the tilt port relief/anti cavitation valve (Item 1) [Figure 20-40-29] from the base end of the tilt section. Replace the O-ring (Item 1) [Figure…
Loosen the lift circuit port relief/anti-cavitation valve (Item 1) [Figure 20-40-27]. Replace the O-ring (Item 1) [Figure 20-40-28] before installation. Installation: Tighten to 38 –…
At the back side of the control valve, remove the lift section anti-cavitation valve (Item 1) [Figure 20-40-24]. Installation: Always use new O-ring (Item 1)…
At the front side of the control valve locate the tilt section load check valve (Item 1) [Figure 20-40-22]. At the front side of the…
Remove the fitting (Item 1) [Figure 20-40-19] from the check valve. Remove the lift load check valve (Item 2) [Figure 20-40-19]. Installation: Lubricate the O-ring…
Lift and block the loader. (See Procedure on Page 10-10-1.) Raise the lift arms and install an approved lift arm support device. (See Installing on…