Remove the retainer nut (Item 1) [Figure 20-21-7] and bolt from the base end pivot pin. Installation: Tighten the retainer nut and bolt to 25…

Remove the old seal (both sides) from the end of the tilt cylinder [Figure 20-21-6]. Apply a light coat of grease on the new seals…

Remove the attachment. Roll the Bob-Tach forward and lower the lift arms. Place the Bob-Tach flat on a pallet to allow the tilt cylinder base…

Remove the attachment. Roll the Bob-Tach fully back. Stop the engine. Raise the seat bar. Disconnect the hose (Item 1) [Figure 20-21-1] which goes to…

Use the following tools to service the cylinder: MEL1074 – O-ring Seal Hook Spanner Wrench MEL1033 – Rod Seal Installation Tool MEL1396 – Seal Installation…

Stop the engine. Pull up on the lift arm bypass control to release the hydraulic pressure. Open the rear door and disconnect the negative ground…

Lower the lift arms. Stop the engine. Pull up on the lift arm bypass control to release the hydraulic pressure. Check only one cylinder at…

The following troubleshooting chart is provided for assistance in locating and correcting problems which are most common. Many of the recommended procedures must be done…