Stop the engine and open the rear door.
Disconnect the charge pressure sender connector (Item 1), temperature sender connector (Item 2) and differential
pressure switch connector (Item 3) [Figure 20-70-1] from the filter housing.
Disconnect the oil cooler tubeline (Item 1) [Figure 20-70-2] from the filter housing.
Disconnect the hose (Item 2) [Figure 20-70-2] from the filter housing outlet.
Remove the two mounting bolts (Item 1) [Figure 20-70-3] from the filter housing mounting bracket.
Installation: Tighten the mounting bolts to 190-240 ins.-lbs. (29,2-36,7 Nm) torque.
Remove the hydraulic filter housing (Item 1) [Figure 20-70-4] from the mounting brackets.
Installation: Tighten the mounting bolts to 375-400 ins.-lbs. (42,4-45,2 Nm) torque.
Remove the filter from the hydraulic filter housing.
Reverse the removal procedure to install the filter housing and filter.
