Remove the lock nut (Item 1) and spacer (Item 2) [Figure 70-60-14]. Installation: Tighten the nut to 45-55 ft.-lbs. (61-75 Nm) torque. Use the following…

To replace the blower housing grill, remove the four mounting bolts (Item 1) [Figure 70-60-13] from the grill. Install the new grill and replace the…

Put jackstands under the rear corners of the loader. Raise the lift arms and install an approved lift arm device. (See Installing Lift Arm Support…

Loosen the idler pulley bolt (Item 1) [Figure 70-60-1]. Installation: Install the retainer bracket (Item 2) [Figure 70-60-1] for the fan belt at the 3…

Stop the engine and open the rear door. Loosen the radiator cap (Item 1) [Figure 70-50-1] from the radiator fill neck. Remove the rear grill.…

Disconnect the wire harness connector (Item 1) [Figure 70-40-1] from the air cleaner sensor on the air cleaner. Loosen the hose clamp (Item 1) [Figure…

Open the rear door and raise the rear grill. Remove the exhaust pipe clamp (Item 1) from the muffler (Item 2) [Figure 70-30-1]. Disconnect the…

Loosen the two control lever mounting bolts (Item 2) [Figure 70-20-1] and remove the mounting nuts (Item 2) [Figure 70-20-3]. Assembly: Do not lubricate the…

Raise the lift arms and install an approved lift arm device. (See Installing Lift Arm Support Device on Page 10-20-1.) Raise the operator cab. (See…

NOTE: The key Switch fully left position activates solenoids number 1 and 4. The high flow rocker switch in the left side instrument panel must…