Stop the engine and open the rear door. Disconnect the connector (Item 1) [Figure 70-70-12]. Remove the linkage mounting nut (Item 1) [Figure 70-70-13] from…

Adjust shut-off linkage for maximum distance of 0.050 inch (1,27 mm) between the lever and stop when solenoid plunger is seated [Figure 70-70-11].    

Stop the engine and open the rear door [Figure 70-70-9]. Disconnect the connector (Item 1) [Figure 70-70-9] from the fuel shut-off solenoid. Use an ohmmeter…

Disconnect the negative (-) cable from the battery. Clean the area around the plugs. Remove the nut (Item 1) [Figure 70-70-6] from the top of…

Disconnect the glow plug cables and leads. Use an ohmmeter to check the glow plugs [Figure 70-70-4]. Touch one probe to the end of the…

The tools listed will be needed to do the following procedure: MEL10630 – Engine Compression Kit MEL1352 – Compression Adapter The engine must be at…

NOTE: For procedures requiring the use of LOCTITE #242 adhesive, thoroughly clean and dry affected parts before the application of LOCTITE #242. The backlash tolerance…

NOTE: (See Gearbox Disassembly on Page 70-60-7.) when ordering parts for the Fan Gearbox. NOTE: Do not install the seals and cap in the housing…

NOTE: When repairing the gearbox order the following as needed. 1. Complete Assembly 2. Long Housing Assembly 3. Long Housing 4. Short Housing Assembly (See…