The wire connector (Item 2) [Figure 60-123-54] can be removed from the solenoid wires, use the following procedure. Remove the wedge (Item 1) [Figure 60-123-55]…

Remove the two bolts (Item 1) [Figure 60-123-52] from the foot sensor shield. Installation: Tighten the bolts to 80-90 in.-lbs. (9,0-10,2 Nm) torque. Disconnect the…

The wire connector (Item 1) [Figure 60-123-49] can be removed from the sensor wires, use the following procedure. Remove the wedge (Item 1) [Figure 60-123-50]…

Remove the two bolts (Item 1) [Figure 60-123-47] from the end of the foot sensor. Installation: Tighten the bolts to 90 in.-lbs. (10,2 Nm) torque.…

With the seat bar down and the ignition key off (keyless panel power off), fully stroke both control handles in toward the center of the…

Switch the rocker switch (Item 1) [Figure 60-123-38] to the hand control mode. With the seat bar down, turn the ignition key on (keyless panel…

The new controller uses a calibration sequence to optimize the control system. The optimizing ensures full spool stroke (full flow) while preventing over stroke (Loading)…

The wire connector (Item 1) [Figure 60-123-35] can be removed from the solenoid, use the following procedure. Remove the wedge (Item 1) [Figure 60-123-36] from…

Remove solenoid (Item 1) from the solenoid mount (Item 2) [Figure 60-123-33]. Installation: Apply a drop of oil to the solenoid threads and tighten solenoid…

Disconnect the harness connector (Item 1) [Figure 60-123-31] from the handle sensor connector. Disconnect the harness connector (Item 2) [Figure 60-123-31] from the handle lock…