Pull the pin (Item 1) [Figure 50-91-1] holding the foot pedal linkage to the sensor. Disconnect the two connectors (Item 2) [Figure 50-91-1] from the…

Remove the hairpin clip and cross-pin (Item 1) [Figure 50-90-9] to disconnect the tilt foot pedal linkage from the control valve. Remove the bolt (Item…

Remove the bolt and nut (Item 1) [Figure 50-90-7] to disconnect the lift foot pedal linkage from the crossbar linkage. Remove the bolt (Item 1)…

Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Raise the operator cab.…

After installing the pedal, adjust the pedal so that there is clearance under the rear of the pedal. The valve spool must travel full stroke…

Remove the bolt (Item 1) [Figure 50-90-1] and nut from the pedal linkage. Installation: Tighten the bolt and nut to 25-28 ft.-lbs. (34-38 Nm) torque.…

Loosen the fuel level sender (Item 1) [Figure 50-80-7] with a wrench. Turn the fuel level sender (Item 1) [Figure 50-80-7] out and remove it…

Remove the cover (Item 1) [Figure 50-80-1] which is installed over the fuel drain near the rear of the chaincase. Installation: Tighten the cover mounting…

Disconnect the spring (Item 1) [Figure 50-70-10] from the rear door. Remove the bolt and nut (Item 2) [Figure 50-70-10] from the latch. Remove the…

Remove the door latch mounting bolts (Item 1) [Figure 50-70-9] from the door latch mechanism. Installation: Tighten the mounting bolts to 80-90 in.-lbs. (9-10 Nm)…