Loosen the striker assembly mount bolts (Item 1) [Figure 50-70-7]. Align the striker assembly in the center of the mounting holes. NOTE: Tighten the striker…

Remove the lock nut (Item 1) [Figure 50-70-6]. Remove the rollers (Item 2) and the spacer (Item 3) from the bolt (Item 4) [Figure 50-70-6].…

Remove the two striker mount bolts (Item 1) [Figure 50-70-4] and [Figure 50-70-5]. Remove the striker assembly from the loader.  

Disconnect the light harness connector (Item 1) [Figure 50-70-1] from the engine harness. Remove both rear lights (Item 2) [Figure 50-70-1] from the door. (See…

Open the rear door and raise the rear grill [Figure 50-60-4]. Remove the gas cylinder rod end (Item 1) [Figure 50-60-5] from the rear grill.…

Open the rear door and raise the rear grill [Figure 50-60-1]. Remove the base end of the cylinder off the stationary ball joint mounted on…

Roll the Bob-Tach fully forward. Stop the engine. Remove the Bob-Tach frame from the lift arms. (See Removal And Installation on Page 50-40-1.) Install jack…

Use the following procedure to remove and install the Bob-Tach lever (Item 1) [Figure 50-41-6], spring and wedge. Use a punch and hammer, remove the…

Tilt the Bob-Tach forward, so it is parallel to the floor. Put blocks (approximately 3 inches) under each side of the Bob-Tach [Figure 50-41-1]. Lower…

Remove and replace the Bob-Tach stop (Item 1) [Figure 50-40-14] (both sides) if worn or damaged. NOTE: The Bob-Tach stop (Item 1) [Figure 50-40-14] must…