Use the following procedure to remove and install the Bob-Tach lever (Item 1) [Figure 50-40-8], spring and wedge. Remove the lever mounting bolt and nut…
Category: BobCat 753
Tilt the Bob-Tach forward, so it is parallel to the floor. Put blocks (Item 1) approximately 3 inches thick under each side of the Bob-Tach.…
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Remove the operator seat. (See Removal And Installation on Page 50-31-1.) Remove the…
Pull the seat back adjustment lever (Item 1) [Figure 50-31-10] and tilt the seat back all the way forward. Remove the two mounting screws (Item…
Press the two buttons (Item 1) [Figure 50-31-6] & [Figure 50-31-7] and lift the seat cushion. Remove the cushion (Item 2) [Figure 50-31-7] from the…
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Remove the operator seat. (See Removal And Installation on Page 50-31-1.) Remove the…
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Remove the four seat mounting nuts (Item 1) [Figure 50-31-1] and washers from…
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Locate the seat belt bolts under seat pan insulation (Items 1 & 2)…
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Remove the four seat mounting nuts (Item 1) [Figure 50-30-1] and washers from…
Remove the operator cab gas cylinder(s). (See Gas Cylinder Removal And Installation on Page 50-20-1.) Remove the heater unit from the cab (if equipped). (See…