Remove the clevis (Item 1) and washer (Item 2) [Figure 50-20-8] from the end of the gas cylinder. Remove the gas cylinder from the outer…

Remove the operator cab stop (Item 1) (both sides) [Figure 50-20-1]. Remove the cab nut and hold down plate (Item 1) [Figure 50-20-2] (both sides).…

Turn the bolt (Item 1) [Figure 50-10-11] & [Figure 50-10-12] out of the clevis. Assembly: Apply LOCTITE #242 adhesive to the bolt threads. Adjust the…

Assemble the parts as shown for the left side of the seat bar pivot assembly [Figure 50-10-7] & [Figure 50-10-8]. Seat Bar Mount (Item 1)…

Raise the seat bar (Item 1) [Figure 50-10-1]. Disconnect the seat bar sensor (Item 1) [Figure 50-10-2] from the cab harness. Lower the seat bar.…

Disconnect the front steering linkage bars from the rear linkage bars. (See Linkage Removal And Installation on Page 50-110-3.) Move the linkage bars to allow…

Disconnect and remove the engine speed control from the control panel. (See Removal And Installation on Page 70-20-1.) Remove the control panel from the loader.…

Raise the loader lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Raise the loader…

To drain the oil from the chaincase, remove the cover (Item 1) [Figure 40-30-2] which is installed over the drain plug at the rear of…

The chaincase contains the final drive sprockets and chains and uses the same type of oil as the hydraulic/ hydrostatic system. (See Hydraulic System on…