Remove the check valve (Item 1)[Figure 20-41-35]. Installation: Tighten the valve to 20 ft.-lbs. (27 Nm) torque. Remove the O-rings (Item 1) and back-up ring…

Remove the fitting (Item 1) [Figure 20-41-32] from the valve. Using a flat blade screw driver, remove the lift arm by-pass orifice (Item 1) [Figure…

Remove the hydraulic control valve. (See BICSTM Valve, Removal And Installation on Page 20-41-9.) To remove the BICSTM from the control valve loosen and remove…

Remove the two screws (Item 1) [Figure 20-41-25] on the actuator retainer. Installation: Tighten the bolt and nut to 90-100 in.-lbs. (10,2-11,3 Nm) torque. Pull…

Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Raise the lift arms and install an approved lift arm support…

Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Raise the lift arms and install an approved lift arm support…

The Advanced Control System (ACS) includes the Advanced Hand Controls (AHC) and/or the Selectable Hand/Foot Control.

Clean all components with clean solvent and dry with compressed air. Check the spools for wear or scratches. Check that the spools are not loose…

Remove the plug (Item 1) [Figure 20-40-119] or optional port relief valve from the control valve. NOTE: Optional port relief (Item 1) [Figure 20-40-119] is…

Remove the nut (Item 1) [Figure 20-40-116] from both solenoids. Installation: Tighten the nut to 8-12 ft.-lbs. (11-16 Nm) torque. Remove the coil (Item 1)…