Remove the screws (Item 1) [Figure 20-40-114] from the end cap (both sides). Installation: Tighten the bolt to 90-100 in.-lbs. (10,2-11,3 Nm) torque. Remove the…

Remove the lift and tilt lock block (Item 1) [Figure 20-40-106] from the control valve. (See Lift And Tilt Lock Block Removal And Installation on…

The tool listed will be needed to do the following procedure: MEL1278 – Detent Tool MEL1285 – Detent Spring Tool Remove the lift and tilt…

Remove the lock solenoids (Item 1) [Figure 20-40-68] & [Figure 20-40-69] from the lock block. Remove the rubber Boot (Item 2) [Figure 20-40-68] & [Figure…

Remove the two screws (Item 1) [Figure 20-40-66] on the rubber boot retainer. Installation: Tighten the screws to 90-100 in.-lbs. (10,2-11,3 Nm) torque. Remove the…

Remove the plug (Item 1) [Figure 20-40-64] (Port F2).or optional port relief valve from the control valve. Installation: Always use new O-rings and back-up washers.…

Remove the anti-cavitation valve (Item 1) [Figure 20-40-60] (Port E2) from the control valve for the tilt section. Installation: Always use new O-rings and back-up…

Loosen the port relief valve (Item 1) [Figure 20-40-58](Port E1). Installation: Always use new O-rings and back-up washers. Tighten to 35-40 ft.-lbs. (47-54 Nm) torque.…

Loosen the main relief valve (Item 1) [Figure 20-40-56]. Remove the main relief valve. Installation: Always use new O-rings, sleeve, and glide ring. Tighten to…

Remove the BICS valve assembly from the control valve. (See BICSTM Valve, Removal And Installation on Page 20-41-9.) Remove the four large O-rings (Item 1)…