Remove the four motor cover mounting bolts (Item 1) [Figure 20-30-6]. Clean the area around the control valve. Loosen and remove the main relief valve…

If the relief pressure is not correct, adjust the main relief valve. Remove the end cap (Item 1) [Figure 20-30-5]. Turn the adjusting screw in…

The tools listed will be needed to do the following procedure: MEL10003 – Hydraulic Tester MEL10006 – Hydraulic Test Kit NOTE: The procedure listed below…

Use the following tools to assemble the cylinder: MEL 1396 – Seal Installation Tool MEL 1033 – Rod Seal Installation Tool Piston Ring Compressor Spanner…

Use the following tools to disassemble the cylinder: MEL 1074 – O-ring Seal Hook Spanner Wrench Hold the hydraulic cylinder over a drain pan and…

Disconnect the hoses (Items 1 & 2) [Figure 20-22-3] from the cylinder fittings. Install plugs and cap in fittings. Remove the bolts (Item 1) [Figure…

Tilt the Bob-Tach forward, so it is parallel to the floor [Figure 20-22-1]. Disconnect the hose (Item 1) [Figure 20-22-1] from the power Bob-Tach cylinder…

Use the following tools to assembly the cylinder: MEL1396 – Seal Installation Tool MEL1033 – Rod Seal Installation Tool Piston Ring Compressor Spanner Wrench Wash…

Use the following tools to disassemble the cylinder: MEL1074 – O-ring Seal Hook Spanner Wrench Hold the hydraulic cylinder over a drain pan and move…