The right instrument panel shown [Figure 60-50-2] is the Key Switch Panel. The table below shows the icons and other components of the Right Key…

The left instrument panel is the same for both the Key Switch and Keyless Instrument Panels [Figure 60-50-1]. The table below shows the DESCRIPTION and…

Stop the engine and open the rear door. Remove the negative (-) and positive (+) cables from the battery. Disconnect the ground wire (Item 1)…

The key switch must be in the OFF position. The battery must be at full charge. The cable connections on the battery must be clean…

Place jackstands under the rear corners of the loader. Raise the lift arms and install an approved lift arm support device. (See Installing on Page…

Turn engine OFF and remove the L & S Terminal connector (Item 1) [Figure 60-30-4] off the alternator. Check the continuity between the “S” terminal…

Turn engine OFF and remove the L & S terminal connector (Item 1) [Figure 60-30-4] off the alternator. Turn the remote start tool key to…

Open the rear door. Connect the remote start tool to the loader. (See REMOTE START TOOL KIT-MEL1563 on Page 10-60-1.) Turn the engine on with…