Use the following tools to disassemble the cylinder: MEL 1074 – O-ring Seal Hook Spanner Wrench Hold the hydraulic cylinder over a drain pan and…
Author: Jack
Disconnect the hoses (Items 1 & 2) [Figure 20-22-3] from the cylinder fittings. Install plugs and cap in fittings. Remove the bolts (Item 1) [Figure…
Tilt the Bob-Tach forward, so it is parallel to the floor [Figure 20-22-1]. Disconnect the hose (Item 1) [Figure 20-22-1] from the power Bob-Tach cylinder…
Use the following tools to assembly the cylinder: MEL1396 – Seal Installation Tool MEL1033 – Rod Seal Installation Tool Piston Ring Compressor Spanner Wrench Wash…
Use the following tools to disassemble the cylinder: MEL1074 – O-ring Seal Hook Spanner Wrench Hold the hydraulic cylinder over a drain pan and move…
Remove the old seal (both sides) from the end of the tilt cylinder [Figure 20-21-8]. Apply a light coat of grease on the new seals…
Disconnect both hydraulic hoses (Items 1 & 2) [Figure 20-21-3]. Remove the retainer nut (Item 1) [Figure 20-21-4] from the cylinder rod end pivot pin.…
Remove the attachment. Roll the Bob-Tach fully back. Stop the engine. Raise the seat bar. Disconnect the hose (Item 1) [Figure 20-21-1] which goes to…