Remove the lock valves (Item 1) [Figure 20-40-41], [Figure 20-40-42] & [Figure 20-40-43] from the BICSTM valve. Installation: Tighten the lock valves to 25 ft.-lbs.…
Author: Jack
Remove the check valve (Item 1) [Figure 20-40-38]. Installation: Tighten the valve to 20 ft.-lbs. (27 Nm) torque. Remove the O-rings (Item 1) and back-up…
Remove the fitting (Item 1) [Figure 20-40-35] from the valve. Using a flat blade screw driver, remove the lift arm by-pass orifice (Item 1) [Figure…
Remove the control valve. (See BICSTM Valve Removal And Installation on Page 20-40-10.) To remove the BICSTM from the control valve loosen and remove the…
Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Raise the lift arms and install an approved lift arm support…
Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Raise the lift arms and install an approved lift arm support…
Remove the four motor cover mounting bolts (Item 1) [Figure 20-30-6]. Clean the area around the control valve. Loosen and remove the main relief valve…
If the relief pressure is not correct, adjust the main relief valve. Remove the end cap (Item 1) [Figure 20-30-5]. Turn the adjusting screw in…
The tools listed will be needed to do the following procedure: MEL10003 – Hydraulic Tester MEL10006 – Hydraulic Test Kit NOTE: The procedure listed below…
Use the following tools to assemble the cylinder: MEL 1396 – Seal Installation Tool MEL 1033 – Rod Seal Installation Tool Piston Ring Compressor Spanner…