The controller uses a calibration sequence to optimize the control system. The optimizing ensures full spool stroke (full flow) while preventing over stroke (loading) of…

[Figure 60-160-1] Excessive actuator loading can occur if the actuator and valve spool components are misaligned. Misalignment may reduce spool stroke performance and reduce the…

Calibration procedures must be followed when replacing a hydraulic control valve, actuator, Drive / Drive+ Controller, ACS Controller, pump controller, hydrostatic pump, or hydrostatic motor.…

The tools listed will be needed to do the following procedure: Order from Bobcat Parts P/N: 6689779 – Remote Start Tool (Service Tool) Kit Kit…

The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL1565 – Service Tool Harness Control MEL1566…

NOTE: All diagnostics must be done at the fourteen pin connector (Item 1). (If so equipped as a dealer installed kit.) The ACD (Attachment Control…

NOTE: All diagnostics must be done at the fourteen pin connector (Item 1). The ACD (Attachment Control Device) Icon, located in the right instrument panel…

Remove the two bolts (Item 1) [Figure 60-130-30] from the foot sensor shield. Installation: Tighten the bolts to 80 – 90 in.-lb. (9,0 – 10,2…

Remove the two bolts (Item 1) [Figure 60-130-28] from the end of the foot sensor. Installation: Tighten the bolts to 90 in.-lb. (10,2 N•m) torque.…

Remove solenoid (Item 1) from the solenoid mount (Item 2) [Figure 60-130-26]. Installation: Apply a drop of oil to the solenoid threads and tighten solenoid…