Remove the main relief valve (Item 1) [Figure 20-40-116]. Remove the O-rings (Item 1) [Figure 20-40-117] from the main relief valve. Installation: Always use new…

Remove the tubeline (Item 1) and fitting (Item 2) [Figure 20-40-114] from the valve. Check the lift arm bypass orifice (Item 1) [Figure 20-40-115]. NOTE:…

Locate the two BICS lock valves, (Item 1) is for the tilt circuit and (Item 2) [Figure 20-40-107] is for the lift circuit. Remove the…

Remove the nut (Item 1) [Figure 20-40-103] from the solenoid stem. Installation: Tighten the nut to 53 in.-lb. (6 N•m) torque. Remove the solenoid coil…

Remove the nut (Item 1) [Figure 20-40-99] from both solenoids. Installation: Tighten the nut to 48 – 72 in.-lb. (5 – 8 N•m) torque. Remove…

Remove the three screws (Item 1) [Figure 20-40-93] from the spool centering block. Installation: Tighten the bolt to 90 – 100 in.-lb. (10 – 11,3…

Remove the lift and tilt end cap/spool lock block. (See End Cap/Spool Lock Block Removal And Installation on Page 20-40-13.) Remove the spacer (Item 1)…

The tool listed will be needed to do the following procedure: MEL1278 – Detent Tool MEL1285 – Detent Spring Tool Remove the end cap/spool lock…

Remove the lift spool lock solenoid (Item 1) and the tilt spool lock solenoid (Item 2) [Figure 20-40-43] from the end cap/spool lock block. Disconnect…

Remove the three screws (Item 1) [Figure 20-40-41] on the rubber boot retainer plate. Installation: Tighten the screws to 90 – 100 in.-lb. (10 -11,3…