Install jackstands under the rear corners of the loader. Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm…

Raise the lift arms 6 feet (2 m) off the ground. Stop the engine. Turn the Lift Arm By-Pass Control Knob clockwise 1/4 turn. Then…

Clean all components with clean solvent and dry with compressed air. Check the spools for wear or scratches. Check that the spools are not loose…

Remove the plug (Item 1) [Figure 20-41-84] or optional port relief valve from the control valve. NOTE: Optional port relief (Item 1) [Figure 20-41-84] is…

Remove the nut (Item 1) [Figure 20-41-80] from both solenoids. Installation: Tighten the nut to 8-12 ft.-lbs. (11-16 Nm) torque. Remove the end plate (Item…

Remove the screws (Item 1) [Figure 20-41-77] from the end cap (both sides). Installation: Tighten the bolt to 90-100 in.-lbs. (10,2-11,3 Nm) torque. Remove the…

Put the linkage end of the spool in the vice [Figure 20-41-73]. Install the spool tool (Item 1) [Figure 20-41-73] over the centering spring. Remove…

Remove the actuators (Item 1) [Figure 20-41-70] from the control valve. (See Actuator Removal And Installation on Page 20-41-8.) Remove the screws (Item 1) [Figure…

Remove the actuator (Item 1) [Figure 20-41-67] from the control valve. (See Lift Spool Removal And Installation on Page 20-41-22.) Remove the screws (Item 1)…

Remove the anti-cavitation valve (Item 1) [Figure 20-41-64] and (Item 1) [Figure 20-41-65] from the control valve.