Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Turn the fan switch…

Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Turn the fan switch…

NOTE: The key must be put in the ON position when checking for power in circuits. Remove the mount bolt (Item 1) [Figure 80-30-10] from…

There are two different methods when cleaning the heater coil. The EARLY style requires you to remove the whole heater assembly to access the heater…

Remove the two mount bolts (Item 1) [Figure 80-20-1] & [Figure 80-20-2] from the fresh air filter cover at the rear of the loader cab.…

Heater Unit: The heater (Item 1) [Figure 80-10-1] is located behind the loader cab. The unit delivers the warm air for heat into the cab.…

Remove the water pump from the timing gearcase cover [Figure 70-100-86]. Put the water pump in a vise and remove the nut [Figure 70-100-87]. Remove…

Use a gauge to check the inside measurement of the cylinder bore [Figure 70-100-84]. Measure the six points as shown in [Figure 70-100-85] to find…

Put the crankshaft on V-blocks. Install a dial indicator on the center journal [Figure 70-100-73]. Turn the crankshaft at a slow rate. If the misalignment…