The tool listed will be needed to do the following procedure: MEL1278 – Detent Tool MEL1285 – Detent Spring Tool Remove the end cap/spool lock…

Remove the lift spool lock solenoid (Item 1) and the tilt spool lock solenoid (Item 2) [Figure 20-40-43] from the end cap/spool lock block. Disconnect…

Remove the three screws (Item 1) [Figure 20-40-41] on the rubber boot retainer plate. Installation: Tighten the screws to 90 – 100 in.-lb. (10 -11,3…

At the top side of the control valve, remove the plug (Item 1) [Figure 20-40-37]. Installation: Always use new O-rings (Item 1) [Figure 20-40-38]. Tighten…

Remove the port relief plug (Item 1) [Figure 20-40-33] from the auxiliary circuit of the control valve. Installation: Always use new O-rings (Item 1) [Figure…

Remove the tilt port relief/anti cavitation valve (Item 1) [Figure 20-40-31] from the rod end of the tilt section. Replace the O-ring (Item 1) [Figure…

Remove the tilt port relief/anti cavitation valve (Item 1) [Figure 20-40-29] from the base end of the tilt section. Replace the O-ring (Item 1) [Figure…

Loosen the lift circuit port relief/anti-cavitation valve (Item 1) [Figure 20-40-27]. Replace the O-ring (Item 1) [Figure 20-40-28] before installation. Installation: Tighten to 38 –…

At the back side of the control valve, remove the lift section anti-cavitation valve (Item 1) [Figure 20-40-24]. Installation: Always use new O-ring (Item 1)…

At the front side of the control valve locate the tilt section load check valve (Item 1) [Figure 20-40-22]. At the front side of the…