Inspect cartridges, check valves, solenoid valves and sealing washers for contamination or damage. Wash all parts in clean solvent. Use air pressure for drying them.…

Clean the diverter block to remove dirt before disassembly. Block ports are labeled for correct assembly. Remove the logic cartridge valves from block ports LC1…

Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Raise the lift arms and install an approved lift arm support…

Remove the solenoid nut (Item 1) [Figure 20-90-9]. Installation: Tighten the nut to 60 in.-lbs. (6,78 Nm) torque. Remove the solenoid (Item 1) and the…

Start the engine. Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Stop…

Use a test meter to measure coil resistance [Figure 20-90-4]. Coil wires do not have polarity. Correct resistance for the coil is 5-8 ohms.  

Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Remove the Bobcat controller mount from the frame. (See Removal And Installation on…

Start the engine. Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Stop…

Stop the engine and open the rear door. Disconnect the charge pressure sender connector (Item 1), temperature sender connector (Item 2) and differential pressure switch…

Mark the pump sections for correct assembly [Figure 20-61-23]. Remove the four smaller pump housing bolts (Item 1) [Figure 20-61-23]. Remove the four larger pump…